Introduction The MAX9503 / MAX9505 DirectDrive video filter amplifier integrates an analog switch (MAX9505) and a negative pressure charge pump. These devices use a single 2.7V to 3.6V power supply and can be directly connected to the output of the video DAC, placing the black level of the video signal at ground potential at the output. These devices eliminate the need for additional negative power supplies and large output DC blocking capacitors, thereby reducing system cost and saving board area. As can be seen from the discussion below, negative pressure charge pumps and analog switches can improve audio / video system performance. Adjusting the level of the sync tip using a negative-pressure charge pump. When the voltage range of the MAX9503 / MAX9505 input sync tip is 0 to 50mV, the output black level is between -0.1V and 0.1V. In some applications, the sync tip voltage output by the DAC can exceed 50mV. In this case, the black level voltage output by the MAX9503 / 5 may exceed 100mV. If the output black level voltage is equal to the ground potential, the input voltage can be adjusted using the circuit shown in Figure 1 to adjust the output black level. Assuming a DAC load of 150Î©, connect a 13kÎ© resistor between the input and CPVSS (-3.3V) of the negative pressure charge pump. The resistor divider network shifts the input voltage of the filter amplifier down by about 40mVP-P. Using this resistor divider network, the noise ripple at the input of the filter amplifier is less than 0.5mV and can be ignored.
Figure 1. Using the MAX9503 / MAX9505 to adjust the input voltage to change the output. The use of analog switches for black level audio / video applications is shown in Figure 2. The MAX9505 integrates an analog switch connected to an external four-hole multimedia socket, video output, and microphone input Share a pin. The switching action is controlled by the logic level of the MODE0 and MODE1 pins. When using the microphone input, the analog switch is closed; the audio signal enters the baseband chip through the switch; the video filter amplifier is disabled, and the output is high impedance. R1 and R2 set the bias voltage of the audio signal to 1.4V. The bandwidth of the analog switch is 200MHz, which is used for video signal switching. Figure 3 shows the application of the MAX9505 in bidirectional video input / output switching. R3 is the 75Î© termination resistor of the external input video signal.
Figure 2. The MAX9505's analog switch is connected to a four-hole multimedia socket
Figure 3. MAX9505 is used for bidirectional video signal input / output
Heavy Duty Connector, also known as HDC, is widely used in construction machinery, textile machinery, packaging and printing machinery, tobacco machinery, robots, rail transit, heat runner, electric power, automation and other equipment requiring electrical and signal connection. The international advanced features of Heavy Duty Connectors in structural design and material usage make the connectors outstanding in electrical performance.The reliability of the electrical connection system can not be achieved by the traditional connection method.
Heavy Duty Connector Inserts are mainly used for electrical and signal connection between different equipments and function units , its rich combination bring more convenience and effectively simplify wiring connection even in the complex wiring environment.
Heavy Duty Connector Inserts
Ip68 Cable Connector,24 Pin Heavy Duty Connector,Heavy Duty Connector Inserts,Duty Heavy Electrical Cable Connectors
Suzhou WeBest Electronics Technology Co.Ltd , https://www.webestet.com